SIFCO ASC
SIFCO ASC
5708 E. Schaaf Road Independence
Ohio 44131
Phone: 1.800.765.4131
Fax: 1.216.524.6331
Email: info@sifcoasc.com
Website: www.sifcoasc.com
Print Back
The SIFCO Process Traversing Arm provides mechanical oscillation or traversing motion for an otherwise manually-moved plating handle. Use of the SIFCO Process Traversing Arm eliminates the need to have an operator move a plating tool, decreasing operator fatigue and freeing him or her to perform other tasks. The mechanical motion control supplied by the Traversing Arm will improve the efficiency of any plating or anodizing operation, and will help to decrease plating cycle time, maximize deposit quality and improve uniformity. The Traversing Arm will accommodate all standard SIFCO Process plating tool handles, providing motion to virtually any size anode which can be attached to the plating tool handle. Speed control and effective length of movement are both easily adjustable for this unit.
Unit of Measure

Specifications

Drive Unit

 N/A 248 watt (1/3 hp) permanent magnet DC gearmotor, with variable speed control.

Rotating Speed

 N/A Infinitely adjustable, 0-100 percent of motor speed (approximately 0 to 350 oscillations per minute [or rpm])

Linear Speed
Tee Nut set at 25.4 mm (1 inch) Radius

 N/A 10 m/min at 100 rpm 33.3 ft/min at 100 rpm

Oscillating Speed
Tee Nut set at 25.4 mm (1 inch) Radius
Link Arm Length 559 mm (22 inch) Overall

 N/A 28 m/min at 100 rpm 91.6 ft/min at 100 rpm

Linear Speed
Tee Nut set at 50.8 mm (2 inch) Radius

 N/A 20 m/min at 100 rpm 66.67 ft/min at 100 rpm

Oscillating Speed
Tee Nut set at 50.8 mm (2 inch) Radius
Link Arm Length 559 mm (22 inch) Overall

 N/A 183.3 ft/min at 100 rpm 56 m/min at 100 rpm

Power Requirements

 N/A 115 VAC, 1Ø, 50/60 Hz, 3 amp