The SIFCO Process Model N Turning Head will provide years of trouble-free service as a light to medium duty rotating device. The turning head consists of a heavy-duty steel base, supporting a speed control and gear motor assembly with a drive bearing-mounted shaft, grounding bar and chuck. A power takeoff on the motor can be used to drive a Rotary Tool Handle or grinding accessory. Attaching the ROTO-FLO Flexible Shaft to the chuck allows to plate a vide range of ID surfaces. The right angle gearbox is coupled to a shaft supported by two sealed, heavy-duty, self-aligning pillow block type bearings. These bearings are equipped with convenient grease fittings to aid in the maintenance of the unit. A quality steel chuck is attached to a stainless steel back plate mounted on the shaft. This 3 jaw chuck comes complete with internal and external jaws, and a chuck wrench.
Unit of Measure
Specifications
Handle to Anode Thread Size
N/A1 in. -8 UNC male thread
For Bore Sizes
N/AFrom approximately 38 to 127 mm (1.5 to 5 in.)
Flexible Cable
N/A91 cm (3 ft) long; 5 Nm (5 lb-in.) maximum dynamic torque at 64 cm (25 in.) radius of curvature.
