Job Shop Plating

Selective Plating Products

All Categories > Plating Products and Solutions > Auxiliary Plating Equipment > Turning Head Model N > Item # 10503050  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # 10503050, Turning Head Model N



The SIFCO Process Model N Turning Head will provide years of trouble-free service as a light to medium duty rotating device. The turning head consists of a heavy-duty steel base, supporting a speed control and gear motor assembly with a drive bearing-mounted shaft, grounding bar and chuck. A power takeoff on the motor can be used to drive a Rotary Tool Handle or grinding accessory. Attaching the ROTO-FLO Flexible Shaft to the chuck allows to plate a vide range of ID surfaces. The right angle gearbox is coupled to a shaft supported by two sealed, heavy-duty, self-aligning pillow block type bearings. These bearings are equipped with convenient grease fittings to aid in the maintenance of the unit. A quality steel chuck is attached to a stainless steel back plate mounted on the shaft. This 3 jaw chuck comes complete with internal and external jaws, and a chuck wrench.





Specifications

Drive Unit

1/3 hp permanent magnet DC gearmotor with reversible, variable speed control box

Chuck Capacity

152 mm (6 in.) maximum diameter, with 610 mm (24 in.) maximum length. Internal and external jaws, for parts up to 23 kg (50 pounds)

Rotating Speed

Adjustable from 0 to 500 rpm

Power Requirements

230 VAC, 1Ø, 50/60 Hz, 3 amp