Job Shop Plating

Selective Plating Products

All Categories > Plating Products and Solutions > Auxiliary Plating Equipment > Turning Head Model N > View Items  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Turning Head Model N

Check up to five results to perform an action.

The SIFCO Process Model N Turning Head will provide years of trouble-free service as a light to medium duty rotating device. The turning head consists of a heavy-duty steel base, supporting a speed control and gear motor assembly with a drive bearing-mounted shaft, grounding bar and chuck. A power takeoff on the motor can be used to drive a Rotary Tool Handle or grinding accessory. Attaching the ROTO-FLO Flexible Shaft to the chuck allows to plate a vide range of ID surfaces. The right angle gearbox is coupled to a shaft supported by two sealed, heavy-duty, self-aligning pillow block type bearings. These bearings are equipped with convenient grease fittings to aid in the maintenance of the unit. A quality steel chuck is attached to a stainless steel back plate mounted on the shaft. This 3 jaw chuck comes complete with internal and external jaws, and a chuck wrench.



   
  Results 1 - 3 of 3 1 

Item #

Item Name

Rotating Speed

Power Requirements

10503000 Turning Head Model N Adjustable from 0 to 500 rpm 115 VAC, 1Ø, 50/60 Hz, 6 amp
10503050 Turning Head Model N Adjustable from 0 to 500 rpm 230 VAC, 1Ø, 50/60 Hz, 3 amp
10700500 ROTO-FLO Assembly N/A N/A
  Results 1 - 3 of 3 1